Kyphosis

- Shape up in Cross 5 and Cross 6

Cross 6_hero banner_2250x600.jpg

Etac Cross 5 and Cross 6, can be set up for both a taller or a shorter users with different body shapes.

The majority of users will use the standard back support. Using the standard back support, the 3A-back support can be adjusted in height from 32 cm to 45 cm. And with the high back support you can get as high as 51 cm. 

Once the desired back height is adjusted and set, the fine tuning of the strap back can be done, and any accessories to support and shape up the posture can be added.

/globalassets/0-international/wheelchairs-and-pressure-care-landing-page/body-shapes-cross-5-and-6-and-prio-3a/cross-5-and-6/page---kyphopsis/illustration_cross_accessories_body-shape-kyphosis.jpg?width=1280&Quality=90&rmode=max&scale=down

To accommodate for a kyphosis, the upper Velcro straps shall provide sufficient space, preventing the user from being pushed forward.

Be sure to check the seat to back angle with the pelvic position and tighten the strap in level with PSIS. Adjust the lumbar angle to obtain the best possible balanced head and trunk position.

To add lateral support, use the Plush Wedges (1). Also the small Cell Foam Wedges (2) provide stability. They can be placed below the Plush Wedges (1).

For further lateral stability, use the Side Cushions (3), supported by Straight Side Stops (4). Check the user´s propulsion abilities. Smaller rear wheels can facilitate the arm movements.

 

green-line-2205x10.jpg

soft_wedge_800x450.jpg

1. Plush wedges

Available in two lengths, short (15 cm/6") and long (30 cm/12"). Usually the short model is sufficient. Attach the wedges with the Velcro facing forward, towards the back cover.
Etac-cellfoam-wedges-800x450.jpg

2. Cell Foam Wedges

These cell foam wedges are slightly wider but lower than the plush wedges. Self adhesive Velcro is included as standard.

Attach the wedges under the back cover, with the Velcro facing forward.
etac-side-support-mounted-800x450.jpg

3. Side cushion

Firm cushions with padding towards the user. The cover has a zipper to enable individual contouring with added foam.

They are 29 cm (11½") high and can be rotated for slimmer upper support.
Side-stops-800x450.jpg

4. Straight Side Stops

The side stops can be used as a support for the side cushion.

They are easily mounted into the back rail and can be adjusted in height, angle and depth.
green-line-2205x10.jpg
/globalassets/0-international/wheelchairs-and-pressure-care-landing-page/body-shapes-cross-5-and-6-and-prio-3a/accessories---body-shape/side-cushions--800x400.jpg?width=1280&Quality=90&rmode=max&scale=down

Example of accessory placement

Example of accessories placed on the back support. Here with the side cushion, along with the straight side stops, on both sides to give an embracing support.

See all body shapes and learn how to shape them up.

Go to body shapes